![]() Employment Opportunity / RFQ (Request for Quote).a When gears are preshave cut on a gear shaper the dedendum will usually need to be increased to 1.40/P to allow for the higher fillet trochoid produced by the shaper cutter. ![]() of e attachmentĪlso mastercam has I think a chook that will create a spline for you if you have this information, if there is not one in mastercam I can do it in Gibbscam and send you file in dxf or dwg format and then you could place dim.'s on it or extrude the 2d feature into solid and acertain whats needed that way. Equations Tooth Parts, 20-and 25-degree Involute Full-depth Teeth ANSI Coarse Pitch Spur Gear Tooth Forms ANSI B6.1. can yu send me the involute callout on t print? If it is shown? it should give pressure angles, pitch diameters, no. My problem is that all I have is the spline call out on the print, and I was counting on them to determine what was going to be needed.We do not manufacture our drive shafts at my facility but we have spine shaft on everyone of our components as well as design authority -I have access to probably every standard out there regarding this an imay be ale to help. I am a complete idiot when it comes to involute splines, so I was hoping someone could some light. The tool manufacture is requesting min and major diameters. The print calls out for a 35 x 2 x 30 x 16 DIN5480. Ive been on the internet for 2 days trying to figure out how to get them the info they need. I was awarded a job that is a shaft with a male spline on it, but don't have enough information to tell the tooling manufacture what to make. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |